Tags:
measure 25.5 inches from where the strings first touch the nut.
or
12 3/4 inches from the 12 fret
I measured a couple of my "real" guitars and it appears to be the longest string, i.e. the low E string.
Measure from the side of the nut closest to the first fret.
On a 25.5" scale, that is the shortest distance your bridge should be placed at, ie the point at which the treble string goes over the saddle..in reality you'll need to add a little compensation to that...and a little more to the bass strings..hence the typical slanted or staggered saddles you'll see on 6 strings.
For a 25.5" the ACTUAL placement of the treble needs to be at 25.59" and the bass at 25.72" according to the StewMac fret position calculator. but bear in mind that's for a 6 string, so your bass string on a 3 or 4 string probably won't need that much compensation, but it all does depend on the string gauges and the action.
Skeesix..either you are measuring wrong or both those guitars have been built wrongly!! The bass strings should usually be a little longer than double the "nut to 12th fret " distance.
CBJ,
Hmmm maybe my measuring tape is off a bit or something as I was measuring a Fender and a Gibson. Now that I think further about it, when I've built guitars, I've made the treble E, the 25.5 or 24.75 and then the bass gets compensated longer like you said.
When building a three string CBG, I actually go by a tuner, so I don't know what the exact length is. First I put the bridge under the strings at 24.75 without gluing, and tune it up to pitch. Then I make the note fretted at the 12th fret, the same as the 12th fret harmonic. When those match up, then the string is compensated correctly.
Then I mark the position of the bridge and glue it on.
If you're using a one piece bridge, one of the strings (I think it's the middle one for a 3 string) may be slightly off, but overall it's going to sound way better than an uncompensated bridge.
Hi Sean,
I always use a movable (aka "floating") bridge and then use my digital tuner to help me find the "optimal" tilt (compensation) for the bridge. To do this, first locate the bridge exactly to 25.5" (in your case) and perpendicular to all three strings. First we'll need adjust for optimal compensation on the first (thinnest) string. So, using the digital tuner, check the open string 1 note, and check the string again with the 12th fret stopped. It should be exactly the same note, just with an octave difference. Most likely these two notes won't be the same, so you will have to move the bridge (usually) out a few millimeters and re-tune the two strings again. Repeat this until you get the open string and octave (12th fret) tuned "spot on" to the same note (with an octave separation), Sometimes, you can't get it spot on, so try to average it out the best you can. Once you have found the optimal bridge location for string 1, mark the soundboard with a pencil where the treble side of the bridge should go. Then repeat the above procedure with string 2, trying to get the open string 2 and its octave (stopped at 12th fret) tuned to the same note (with an octave separation). Then with the third string repeat this process once again. Be sure to mark the bass side of the bridge on the sound board (in pencil). These pencil marks will help you relocate the bridge should it move on you. String tension should be enough to hold it in place most of the time, but maybe you have kids;-) Anyways, usually you will notice a slight slant to the bridge with the base string side a mm or two longer than the treble side. But as compared to six string guitars, the slant of the bridge on a 3-stringer will not as extreme because the string diameters are not that different. This process takes some practice, and I usually don't bother until a couple days after stringing up the guitar so the strings will have some time to settle in.
Because I build mostly stick dulcimers (aka strum sticks, strummers, pick'n sticks, etc.), I usually use the above process on diatonically fretted instruments where the octave is on fret 7 instead of fret 12 (some people call the octave "fret 8" and this occurs with folks who call fret "six and a half" (aka "fret 6.5") "fret 7"). Anyways, what I have noticed is that all I really need to do is to adjust compensation on string 1 since I usually just play strings 2 and 3 as drones (strummed open string). So, in my opinion, it's not really necessary to compensate strings 2 and 3 on a dulcimer (stick or mountain) unless you also play "up the neck" on strings 2 and 3. I don't play this way, so these days I usually just adjust for compensation on string 1. But on chromatic 4-stringers (and more strings), I do go ahead and try to compensate all strings for better intonation up and down the neck.
If my explanation is not clear, just ask me for a clarification.
-Rand.
hey guys, how would you measure a rod piezo installation if im placing it under the bridge, I'm concerned about drilling a hole in the box in the wrong location?
The proper location for a rod piezo is under the base of the bridge (or in the saddle). So align the rod with the length of hardwood wood that you plan to use as your bridge and carve out a channel in the base (where the bridge will sit on the sound board) and tack the piezo in place with some hot glue. Other people build their bridges as a wooden saddle and a bone bridge, in which case the rod piezo would be placed in line with the groove in the saddle under the bone bridge. This will add some height to the bridge, so you may want to file or sand of the bone off the base of the saddle to compensate, You may also need to trim the rod piezo, especially if building a 3 or 4 string CBG. I assume you cut off the excess from the end of the piezo that does NOT have wires attached. I have not actually built with rod piezos, but they interest me and have read about them elsewhere on CBN and the Internet. You can uses CBN's search feature and search on "rod piezo" for more information. Or, Google it.
-Rand.
Started by Bill Andy in Performances, How to Play, Lessons, Concerts. Last reply by Southern Ray May 7. 11 Replies 0 Likes
Started by Bill Andy in Performances, How to Play, Lessons, Concerts. Last reply by Taffy Evans May 5. 6 Replies 0 Likes
Started by J. D. Woods in Performances, How to Play, Lessons, Concerts. Last reply by Southern Ray Apr 26. 8 Replies 1 Like
Started by Southern Ray in Other stuff - off topic, fun stuff, whatever. Last reply by Southern Ray Apr 26. 6 Replies 0 Likes
Started by J. D. Woods in Performances, How to Play, Lessons, Concerts. Last reply by BrianQ. Apr 25. 4 Replies 0 Likes
Started by Rich Butters in Building Secrets, Tips, Advice, Discussion. Last reply by Crazed Fandango Apr 22. 4 Replies 0 Likes
Started by Nomad Jack in Performances, How to Play, Lessons, Concerts. Last reply by J. D. Woods Apr 17. 7 Replies 2 Likes
Started by Moritz Voegeli in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Apr 14. 6 Replies 2 Likes
Started by Timothy Hunter in Other stuff - off topic, fun stuff, whatever. Last reply by Timothy Hunter Apr 10. 14 Replies 3 Likes
Started by Tom T in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Apr 9. 9 Replies 0 Likes
Started by Southern Ray in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Apr 4. 7 Replies 1 Like
Started by Timothy Hunter in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Mar 27. 1 Reply 2 Likes
Started by Taffy Evans in Building Secrets, Tips, Advice, Discussion. Last reply by Southern Ray Mar 10. 1 Reply 3 Likes
Started by Cigar Box Nation in Feature Articles. Last reply by BrianQ. Mar 9. 4 Replies 3 Likes
Started by Ghostbuttons in Building Secrets, Tips, Advice, Discussion. Last reply by Timothy Hunter Mar 9. 5 Replies 1 Like
Started by Justin Stanchfield in Building Secrets, Tips, Advice, Discussion. Last reply by Taffy Evans Mar 8. 6 Replies 0 Likes
Started by Ken I in Building Secrets, Tips, Advice, Discussion. Last reply by Brian partington Mar 8. 8 Replies 0 Likes
Started by Southern Ray in Cool gear discussion - that's not cigar box related. Last reply by Southern Ray Mar 6. 5 Replies 0 Likes
Started by Taffy Evans in Other stuff - off topic, fun stuff, whatever. Last reply by Taffy Evans Mar 5. 4 Replies 2 Likes
Posted by Vlad on March 31, 2024 at 11:48pm 0 Comments 1 Like
Posted by Vlad on March 6, 2024 at 2:32am 5 Comments 2 Likes
Posted by billy jones bluez on February 28, 2024 at 2:09pm 0 Comments 0 Likes
Posted by billy jones bluez on February 17, 2024 at 11:00pm 0 Comments 0 Likes
Posted by Vlad on February 11, 2024 at 1:06am 1 Comment 1 Like
© 2024 Created by Ben "C. B. Gitty" Baker. Powered by
Cigar Box Nation is presented by C. B. Gitty Crafter Supply, your one-stop-shop for Cigar Box Guitar parts and accessories!